Washing equipment with drive-through function for buses, Sultof Expres

Washing equipment with drive-through function for buses, Sultof Expres

Stationary automatic, 4-brush washer with a lever design, which is designed for the daily washing flow of the bus fleet. In this car wash, buses are washed in pass mode. Basically, the surfaces are washed: the front, sides and rear of the bus. The washing equipment consists of two columns connected at the top by a transverse beam. All posts and levers are made of stainless steel. A specially adapted, patented Sultof solution allows you to safely wash buses with non-folding long right-hand side mirrors.

The movement of the levers and the power of the washing pressure are regulated using special pneumatic controls. Water is sprayed onto the sides and roof of the bus through nozzles located on the entry gates and brush arms. Also, depending on the settings on the control panel, the entrance gate can cover the vehicle with a special washing chemical, and the exit gate can apply wax and wash brushes.

Before entering the brush cleaning area, the vehicle can be washed from below, with specially equipped floor sprayers.

Express washing equipment can be compatible with Sultof Bioclean, an ecotech recycling system that allows reuse of up to 90% of water. Demineralized water can be used for washing buses, which does not leave stains. The 4 wash brushes are 3.4 meters long and can service vehicles in the height range of 0.2 - 3.6 m.

During the washing process, the buses pass through a stationary but pneumatically tilted combination of vertical brushes.

Technical parameters:

• Washing height: 3600 mm
• Washing width: 2550 mm

Additional accessories and components are available:

You can expand these washing systems with various components, such as: washing the bottom of buses, installing a water softening system and water recycling systems.

Equipment prices: