Oscilloscope setup CarScope VISO Master

Oscilloscope setup CarScope VISO Master

The MASTER kit is complete with many necessary accessories for professionals to test various electrical circuit parts in vehicles. Later, if the need arises, the set can be expanded by purchasing separate accessories. You will be able to test all places in the electrical circuit:

Test most engine sensors - lambda, mass air flow (MAF), MAP, ABS, TPS, camshaft/crankshaft position, etc.

Test solenoids etc.

Monitor fuel injector and fuel pump signals

View CAN bus signals

Primary and secondary ignition measurements (supports all systems)

Test batteries, alternators and starter motors

Analyze the performance of the starter

Measure small and large currents in the engine starter, injectors or various solenoid valves

Detect burnt valves, malfunctioning injectors and other engine performance problems without major engine damage

Sets

CarScope VISO main device

Automotive Needle Probe Set (5 Needle Set)

Insulated clamps (2 pairs of clamps)

Attenuator 10:1

Attenuator 20:1

25A terminal black

25A terminal is red

60 amp AC/DC current terminal

600 amp AC/DC current terminal

Pressure pulse sensor

#1 cylinder terminal

Coil-on-plug terminal 2 pcs

Coil-on-plug extension terminal 2 pcs

Suitcase