ADAS calibration system for heavy transport ACS TRUCKS Autocom

Mobile calibration stand with reference targets designed to meet OE measurement requirements for trucks, buses and vans.
A safe solution that complies with manufacturers' calibration procedures.
Mobility and flexibility - fast transport and short set-up times.
Easy to use and clear workflow.
Wide coverage of brands.
Increased workshop competence and the possibility of providing additional services.
Generation of additional income and stronger customer loyalty.
Double-sided calibration targets - one target can be used for two different brands.
After calibration, the possibility to print out a report for the customer as proof of the work carried out.

Mobile ADAS calibration stand for trucks, buses and vans x 1
Universal target holder x 1
Double-sided calibration targets x 1 set
Targets for Volvo and Renault x 1
Targets for MAN, Iveco and Scania x 1
TFC 1 / TFC 2 targets x 1
TFC 5 / TFC 6 targets x 1

TFC 1 / TFC 2 - Front: Volkswagen (Audi, Cupra, Seat, Skoda), Rear: Mercedes (Volvo, Polestar) - for use with universal bracket.
TFC 5 / TFC 6 - Front: Fiat (Hyundai, Jeep, KIA), Rear: Alfa Romeo - to be used with universal bracket.

Operating principle:

• During calibration, the stand is positioned in front or behind the vehicle according to the measurements specified by the OE. The calibration function of the specific ADAS system is activated via the Autocom TRUCKS diagnostic software. The camera or radar reads the geometric and graphic pattern of the target and the control unit processes the data and checks compliance with the tolerances. If deviations are detected, the system generates a DTC error code and a warning is triggered on the vehicle's dashboard. After a successful calibration, the errors are eliminated and the system confirms correct operation.