Your Cart
Engine power tester DynoProject 4WD DP4L SYNCHRO
Engine power tester DynoProject 4WD DP4L SYNCHRO

Engine power tester DynoProject 4WD DP4L SYNCHRO

  • SKU: BD23830
0.00 €

Prices shown include tax

Send Message


Engine power tester DynoProject 4WD DP4L SYNCHRO


Country of origin: DynoProject, Poland



The 4WD DP4L SYNCHRO Engine Power Checker allows you to carry loads of power and torque on two-wheel drive systems (rear or front axle) and four-wheel drive vehicles. Also, this bench can synchronize speed between both axles, which may be needed to make measurements on cars with slip control systems installed.

The DataLogger digital system uses microprocessor technology in the design and guarantees the stability of the measured parameters. All data is scanned live. Measurements are made every 0.1 KM. The microprocessor monitors the operation of the dynamometer and controls the transfer of measured data. The brake controller simulates road conditions by controlling speed and acceleration according to set parameters.

Datalogger reads the values ​​of the following parameters:

• Speed

• Torque

The controller communicates with the software installed on the computer. An advanced yet intuitive program processes the measured parameters and saves them. The collected and processed parameters are displayed in diagrams and figures, which allow detailed diagnostics of engine operation or analysis of engine modernization results.


Technical parameters:

- Maximum speed: 288 km / h

- Maximum wheel torque: 1300+ Nm

- Maximum power: 900+ hp

- Maximum engine torque: 1000+ Nm

- Controller Power Supply: 230V AC, 1A

- Brake Power Supply: 230V, 16A

- Operating temperature: 5 - 35 ° C

- Dimensions: 3800 x 4500 x 500 mm

- Maximum wheelbase: 2100 mm

- Minimum wheelbase: 700 mm

- Weight: 3000 kg